Jaw Width 160

1. In standard design with step jaws for larger clamping ranges
2. with additional clamping range
3. Threaded holes to fasten interchangeable clamping jaws (see accessories)
4. Rugged body from nodular cast iron GGG 60, precision ground, with hardened guide ways
5. Threaded holes for work piece stop on either side
6. In standard design with longitudinal and cross keyways Ř 20 H7  (0.7874”) for alignment on the machine bed and 2 precision holes Ř 25 H6  (0.9843”) for accommodation on zero point clamping systems 
7. Spring plunger for quick step jaw change system
8. Precise selection of clamping force in 8 increments

•  Loosening of two side screws manually
•  turning of the front plate by 90° (bajonet system)
•  pulling of the complete spindle unit
•  best cleaning possibility / best possibility for fixing the body through the center
•  mechanical-hydraulic spindle, completely enclosed, resistant to wear and maintenance free

   
Indispensable for production – quick change parallels

•  quick change parallels are simply “clicked” without tools
•  no chip penetration under the quick change parallels even when using compressed air
•  safe and firm clamping
•  available in different heights (see accessories)

      
Quick jaw change system

•  loosening of 2 screws (one revolution only)
•  jaw can be turned by 180°, or special jaws can be mounted
•  tighten both screws and simply continue to work
•  simply make your own special jaws since the interface between body and jaw does not require a key way connection

With attached angular drive for best accessibility of force adjustment