|Jaw width:||91 - 125 mm|
Optimum accessibility for 5-sided machining
Exact repeatable clamping force by using a torque spanner
The right jaw for every workpiece from our versatile range of jaws
- Optimum chip protection
- Alignment via cross grooves, or via 0-point clamping systems
Any questions?Contact Sales Department
How does the patented quick adjustment of the clamping width work on a mechanical machine vise?
The locking lugs on the spindle can be turned downwards by 180° by hand.
Then the movable jaw can be moved and locked in the desired position.
Adjustment to the workpiece and clamping is done with a 1/2" square torque spanner.
Do chips that fall into the vise cause problems?
Can the Bull 5-S Machine Tool Vise be elevated?
Yes, the Bull 5-S Machine Tool Vise can be raised with a console screwed underneath.
Do the jaws from the Bull Mechanical machine vise also fit on the Bull 5-S Machine Tool Vise?
Yes, all jaws from the Bull Mechanical can be used.
Can the clamping block (carriage) be rotated?
Yes, the clamping block can be pulled out with the jaws to the rear and pushed in again rotated by 180°. This allows the sap width to be changed very quickly.
What are the steel ball-bearings in the jaws used for?
These are spring-loaded pressure points. Our Kesel step ledges (support ledges) can be clicked into these.